The film products plays a very important role in our production and life, including several commonly used film products have thermal transfer film, lithium battery separator, food fresh-keeping film, plastic film and so on, these products have appeared in the film in all walks of life, as the film products manufacturers is to grasp own production, for the production of marketable products, here we come from production for you to make some detailed introduction, hope you know he can fully help.

1 film products in the production process to strictly control the temperature. As long as the film products will be used for temperature, film products, most of the use of polypropylene or polyethylene produced, they are granular, only they can be melted into the colloidal layer a thin film is very thin, if the temperature of overheating if the raw materials melting speed quickly you will drop, the concentration is much, what we need is a gelatinous substance, rather than water like substance, the temperature is too high, it is easy to melt into water like substance, it will waste a lot of raw materials. While the temperature is too low then the gelatinous material will be very hard, it is difficult to achieve for the next step for. Membrane products need to be adjusted several times to achieve a more satisfactory state, the process is sometimes very long, the general business will be debugging for some time before the normal production.

2 maintain the sanitary condition of the workshop when producing the membrane products. The workshop must be clean and tidy, because the film material is most afraid of impurities inside too many impurities, too many words will be very easy to let it broken off after the film, film mechanical equipment must stop working, all procedures can start all over again, even if there is no broken membrane inside impurities it will also affect the quality of the product, when the post detection is unqualified. The most afraid of is that many enterprises take the incorporation of impurities to film terminal demand, leading to these customers of this or that problem when in use, this is very bad for our enterprises, may have lost a large part of the trust of our customers.

3 membrane products in production should pay attention to safety. The security problem is an important problem in front of each production plant, the problem is almost a commonplace talk of an old scholar problem, each enterprise should put safety first, to strengthen the consciousness of employees from all time, let them establish security concept for, only to happen from the top to the overall coordination of the fundamentally eliminate the dangerous situation.

www.ledecable-electronics.com